Selle smp setup

It should not have sharp edges which, by cutting, could compromise saddle frame resistance. The contact area between the seatpost and the saddle frame should not be under 8 cm2. The jaws should connect with the saddle frame for a minimum length of 32 mm. The coupling surfaces with the saddle frame should be symmetrical and parallel.

The jaws should not cause deformation or damage to the saddle frame. The seatpost jaws should not protrude beyond the graphed area. The closing torque recommended by the seatpost manufacturer must be strictly abided by. General Warnings The user of this Selle SMP product acknowledges and accepts all the risks involved in riding a means of transport including, among others, the risk of breaking the saddle that might cause accidents and consequent serious injury and also death.

The cutout is transitioned smoothly so there are no high points which equates to pressure points. All 3 saddles are extremely well built, well engineered, and very high quality, and the FORMA is very very comfortable. Breda, N. Piazza, and V. Sommer, I. Goldstein, and J. Korda, Volume 7, Issue 7, July , pages I have always enjoyed bicycling and, through a series of coincidences, became a Bicycle Industry Consultant and Product Tester.

I continue to test prototype products for companies and publish only off the shelf production products on biketestreviews. Learn more. Place a level object such as a rigid book or wide ruler across the top of the saddle and measure angle with the phone on this surface. Some things to remember: make sure your bike is on a level surface, or the saddle angle will be meaningless. Use a four-foot dowel or other long straight object and lay it next to the wheels, and use the angle finder to confirm the level of the floor.

Also, if your smartphone has buttons or other gizmos on the side which will change the angle relative to the surface to be measured, they must be accounted for, or the other side of the phone can be used for measurement. The measurement is taken from the highest points the tail and the high point of the nose.

Many riders sit further back on a SMP saddle in comparison to traditional saddles. In many cases, in order to keep the same position relative to the bottom bracket, this means placing the SMP mm further forward than the previous saddle. It depends on the rider and the saddle, and may not apply if a rider was previously riding a saddle that was too narrow.

Share this: Twitter Facebook. These parameters are adjusted by the cyclist according to their personal characteristics; for best results it is essential to perform the installation by following the steps in the procedure described in the following pages. Secure the saddle observing the distance from the handlebar and saddle height recommended by the bicycle manufacturer based on your measurements. The weight balance and comfort therefore depend on how the ischial Using a level, adjust tilt using the clamp so that the saddle is horizontal.

The pillar has a significant impact on saddle frame resistance: For this reason Selle SMP recommends a pillar with the following characteristics:.